Your shopping cart is empty!
ASTM International, 05/01/2016
Publisher: ASTM
File Format: PDF
$32.00$65.00
Published:01/05/2016
Pages:12
File Size:1 file , 190 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers a group of common requirements that shall apply to carbon, alloy, stainless steel, and nickel alloy bolting under any of the following ASTM Specifications (or under any other ASTM Specifications that invoke this specification or portions thereof):
Title of Specifications
ASTM Designation
Alloy-Steel and Stainless Steel Bolting Materials for High-Temperature Service
A193/A193M
Carbon and Alloy Steel Nuts for Bolts for High Pressure and High-Temperature Service
A194/A194M
Alloy Steel Bolting Materials for Low-Temperature Service
A320/A320M
Alloy-Steel Turbine-Type Bolting Material Specially Heat Treated for High-Temperature Service
A437/A437M
High-Temperature Bolting Materials With Expansion Coefficients Comparable to Austenitic Stainless Steels
A453/A453M
Alloy-Steel Bolting Materials for Special Applications
A540/A540M
Precipitation-Hardening Bolting Material (UNS N07718) for High Temperature Service
A1014/A1014M
1.2 In case of conflict, the requirements of the individual product specification shall prevail over those of this specification.
1.3 Fasteners are a wide-ranging classification that includes screws, bolts, nuts, washers, stud bolts, rivets, powder-actuated studs, staples, tacks, and pins. Bolting, which is composed of bolting materials, such as rods, bars, flats, and forgings, which are subsequently manufactured into bolting components, are a special sub-group of fasteners. Bolting materials and components have designated compositions and specific properties intended for applications in aggressive service where commercial generic fasteners may not be suitable or have insufficient fitness for purpose under certain conditions. These conditions include cryogenic or high temperature service, or excessive vibration, impact, or shock. To further address any other special service conditions where bolting is intended for use, additional requirements may be specified by mutual agreement between the purchaser and supplier.
1.4 Supplementary requirements are provided for use at the option of the purchaser. The supplementary requirements only apply when specified individually by the purchaser in the purchase order or contract.
1.5 This specification is expressed in both inch-pound units and in SI units. Unless the purchase order or contract specifies the applicable “M” specification designation (SI units) the inch-pound units shall apply. The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
Standard Terminology of Building Economics
$29.00 $58.00
Standard Guide for Using the Electronic Cone Penetrometer for Environmental Site Characterization
$30.00 $60.00
Standard Test Method for Determining Concentration of Airborne Single-Crystal Ceramic Whiskers in the Workplace Environement by Transmission Electron Microscopy
Standard Guide to Interpretation of Radiographs of Semiconductors and Related Devices