• ASTM A966/A966M-07

ASTM A966/A966M-07

Standard Practice for Magnetic Particle Examination of Steel Forgings Using Alternating Current

ASTM International, 05/01/2007

Publisher: ASTM

File Format: PDF

$30.00$60.00


Published:01/05/2007

Pages:6

File Size:1 file , 110 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This practice covers a procedure for the magnetic particle examination of steel forgings using alternating current as the power source. The procedure will produce consistent results upon which acceptance standards can be based. This practice does not contain acceptance limits or recommended quality levels.

1.2 Only alternating 50-60 cycle current shall be used as the electric power source for any of the magnetizing methods. The ability to detect subsurface discontinuities is very limited when using an alternating power source, and therefore the test surfaces should be in the final thermally treated and finish machined condition.

1.3 When subsurface indications are sought in forgings, then dc magnetization in accordance with Test Method A 275/A 275M should be used.

1.4 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. Unless the order specifies the applicable "M" specification designation [SI units], the inch-pound units shall be used.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

More ASTM standard pdf

ASTM F819-04a

ASTM F819-04a

Standard Terminology Relating to Electrical Protective Equipment for Workers

$25.00 $50.00

ASTM D7520-09

ASTM D7520-09

Standard Test Method for Determining the Opacity of a Plume in the Outdoor Ambient Atmosphere

$41.00 $83.00

ASTM E1652-15

ASTM E1652-15

Standard Specification for Magnesium Oxide and Aluminum Oxide Powder and Crushable Insulators Used in the Manufacture of Base Metal Thermocouples, Metal-Sheathed Platinum Resistance Thermometers, and Noble Metal Thermocouples

$32.00 $64.00

ASTM D2500-16a

ASTM D2500-16a

Standard Test Method for Cloud Point of Petroleum Products and Liquid Fuels

$30.00 $60.00