• ASTM A991/A991M-08

ASTM A991/A991M-08

Standard Test Method for Conducting Temperature Uniformity Surveys of Furnaces Used to Heat Treat Steel Products

ASTM International, 10/01/2008

Publisher: ASTM

File Format: PDF

$26.00$52.00


Published:01/10/2008

Pages:4

File Size:1 file , 70 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers the procedures used to conduct a temperature uniformity survey on a furnace used to heat treat steel products. This method is used to determine the capability of the furnace to meet the permissible temperature variation specified in the applicable product specification, or as agreed to by the purchaser and supplier of heat treat services. Survey documentation requirements, and the procedure used to subsequently establish the furnace working zone, are defined in this test method.

1.2 This test method covers heat treat furnaces in any of the following categories:

1.2.1 Continuous or semi-continuous conveyance furnaces,

1.2.2 Batch furnaces, and

1.2.3 Salt or liquid baths and fluidized beds.

1.3 This test method only applies when specified in the product specification or the purchase order.

1.4 Controlling a heat treatment of steel products using thermocouples attached to the extremities of each load is an alternative to performing a furnace survey.

1.5 By mutual agreement between the purchaser and the supplier of heat treat services, more stringent and/or additional requirements may be specified. The acceptance of any such additional requirements shall be dependent on negotiations with the supplier and must be included in the order as agreed upon by the purchaser and supplier.

1.6 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

More ASTM standard pdf

ASTM F608-11

ASTM F608-11

Standard Test Method for Evaluation of Carpet Embedded Dirt Removal Effectiveness of Household/Commercial Vacuum Cleaners

$32.00 $65.00

ASTM E1933-99a(2005)e1

ASTM E1933-99a(2005)e1

Standard Test Methods for Measuring and Compensating for Emissivity Using Infrared Imaging Radiometers

$25.00 $50.00

ASTM D7280-06(2011)

ASTM D7280-06(2011)

Standard Test Method for Quinoline-Insoluble (QI) Content of Tar and Pitch by Stainless Steel Crucible Filtration

$30.00 $60.00

ASTM E2856-11

ASTM E2856-11

Standard Guide for Estimation of LNAPL Transmissivity

$49.00 $98.00