• ASTM A995/A995M-18

ASTM A995/A995M-18

Standard Specification for Castings, Austenitic-Ferritic (Duplex) Stainless Steel, for Pressure-Containing Parts

ASTM International, 01/01/2018

Publisher: ASTM

File Format: PDF

$29.00$58.00


Published:01/01/2018

Pages:5

File Size:1 file , 83 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification covers austenitic-ferritic (duplex) stainless steel castings for valves, flanges, fittings, and other pressure-containing parts.

1.2 The duplex stainless steels offer a combination of enhanced mechanical properties and corrosion resistance when properly balanced in composition and properly heat treated. Ferrite levels are not specified, but these grades will develop a range of approximately 30 to 60 % ferrite with the balance austenite. It is the responsibility of the purchaser to determine which grade shall be furnished depending on design and service conditions, mechanical properties, and corrosion-resistant characteristics.

Note 1: Because of the possibility of precipitation of embrittling phases, the grades included in this specification are not recommended for service at temperatures above 600 °F [315 °C].

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM D6902-04(2011)

ASTM D6902-04(2011)

Standard Test Method for Laboratory Measurement of Formaldehyde Evolved During the Curing of Melamine-Formaldehyde-Based Coatings

$30.00 $60.00

ASTM D1101-97a(2018)

ASTM D1101-97a(2018)

Standard Test Methods for Integrity of Adhesive Joints in Structural Laminated Wood Products for Exterior Use

$21.00 $42.00

ASTM G213-17

ASTM G213-17

Standard Guide for Evaluating Uncertainty in Calibration and Field Measurements of Broadband Irradiance with Pyranometers and Pyrheliometers

$38.00 $76.00

ASTM B37-08(2013)

ASTM B37-08(2013)

Standard Specification for Aluminum for Use in Iron and Steel Manufacture

$26.00 $52.00