Your shopping cart is empty!
ASTM International, 01/10/2000
Publisher: ASTM
File Format: PDF
$26.00$52.00
Published:10/01/2000
Pages:4
File Size:1 file , 20 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification establishes the requirements for free-cutting brass rod, bar, wire, and shapes of any specified cross section produced from Copper Alloy UNS No. C36000 suitable for high-speed screw machining applications and moderate thread rolling.
1.2 The values stated in either inch-pound units or in SI units are to be regarded separately as the standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system shall be used independent of the other. Combining values from the two systems may result in nonconformance with the specification.
Standard Test Method for Critical Radiant Flux of Exposed Attic Floor Insulation Using a Radiant Heat Energy Source
$36.00 $72.00
Standard Test Method for Water in Paints and Paint Materials by Karl Fischer Method
$28.00 $57.00
Standard Test Method for Pull-Off Strength of Coatings on Concrete Using Portable Pull-Off Adhesion Testers
Standard Test Methods for Estimating the Largest Grain Observed in a Metallographic Section (ALA Grain Size)
$26.00 $52.00