Your shopping cart is empty!
ASTM International, 03/01/2005
Publisher: ASTM
File Format: PDF
$30.00$60.00
Published:01/03/2005
Pages:5
File Size:1 file , 83 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification establishes the requirements for free-cutting brass rod, bar, wire, and shapes of any specified cross section produced from Copper Alloy UNS No. C36000 suitable for high-speed screw machining applications and moderate thread rolling.
1.2 UnitsValues stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Test Method for Acidity in Aviation Turbine Fuel
$30.00 $60.00
Standard Specification for Concrete Aggregates
$33.00 $67.00
Standard Practice for Evaluating Activity of Clay Elements Using a Side-Stream Sensor (Withdrawn 2014)
Standard Test Method for Evaluating Asphalt-Covered Concrete Bridge Decks Using Ground Penetrating Radar
$26.00 $52.00