Your shopping cart is empty!
ASTM International, 05/01/2011
Publisher: ASTM
File Format: PDF
$33.00$67.00
Published:01/05/2011
Pages:11
File Size:1 file , 120 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers commercial aluminum alloys in ingot form for remelting and molten form for the manufacture of castings. The specific gravity of these alloys does not exceed 3.0 and they are designated as shown in Table 1.
1.2 Alloy designations are in accordance with ANSI H35.1/H35.1(M). The equivalent Unified Numbering System alloy designations are in accordance with Practice E527.
1.3 Unless the order specifies the “M” specification designation, the material shall be furnished to the inch-pound units.
1.4 For acceptance criteria for inclusion of new aluminum and aluminum alloys in this specification, see Annex A1.
1.5 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.
1.5.1 Exception-Certain SI units appear in brackets in 7.1.2.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Test Method for Determination of Thiodiglycol in Soil Using Pressurized Fluid Extraction Followed by Single Reaction Monitoring Liquid Chromatography/Tandem Mass Spectrometry (LC/MS/MS)
$29.00 $58.00
Standard Practice for Determining the Adhesion of Prints and Laminating Films
Standard Terminology Relating to Steel, Stainless Steel, Related Alloys, and Ferroalloys
Standard Specification for Spray-Applied Rigid Cellular Polyurethane Thermal Insulation
$26.00 $52.00
