ASTM B211M-12

1.1 This specification covers rolled or cold-finished bar, rod, and wire in alloys (Note 1) and tempers as shown in Table 2.

Note 1 - Throughout this specification use of the term alloy in the general sense includes aluminum as well as aluminum alloy.

Note 2 - The term cold finished is used to indicate the type of surface finish, sharpness of angles, and dimensional tolerances produced by drawing through a die.

Note 3 - See Specification B221M for aluminum and aluminum-alloy extruded bars, rods, wire, shapes, and tubes; and Specification B316/B316M for aluminum and aluminum-alloy rivet and cold-heading wire and rods.

1.2 Alloy and temper designations are in accordance with ANSI H35.1M. The equivalent Unified Numbering System alloy designations are those of Table 1 preceded by A9, for example, A91100 for aluminum 1100 in accordance with Practice E527.

1.3 This specification is the metric counterpart of Specification B211.

1.4 For acceptance criteria for inclusion of new aluminum and aluminum alloys in this specification, see Annex A2.

TABLE 1 Chemical Composition Limits^A,B,C,D

Alloy	Si	Fe	Cu	Mn	Mg	Cr	Ni	Zn	Ti	Bi	Pb	Sn	Other ElementsE		Aluminum
													Each	TotalF
1100G	0.95 Si + Fe		0.05-0.20	0.05	...	...	...	0.10	...	...	...	...	0.05	0.15	99.00 minH
2011	0.40	0.7	5.0-6.0	...	...	...	...	0.30	...	0.20-0.6	0.20-0.6	...	0.05	0.15	remainder
2014	0.50-1.2	0.7	3.9-5.0	0.40-1.2	0.20-0.8	0.10	...	0.25	0.15	...	...	0.15	0.05	0.15	remainder
2017	0.20-0.8	0.7	3.5-4.5	0.40-1.0	0.40-0.8	0.10	...	0.25	0.15	...	...	0.15	0.05	0.15	remainder
2024	0.50	0.50	3.8-4.9	0.30-0.9	1.2-1.8	0.10	...	0.25	0.15	...	...	0.15	0.05	0.15	remainder
2219	0.20	0.30	5.8-6.8	0.20-0.40	0.02	...	...	0.10	0.02-0.10	...	...	0.02-0.10	0.05I	0.15I	remainder
3003	0. More ASTM standard pdf ASTM D6794-14 Standard Test Method for Measuring the Effect on Filterability of Engine Oils After Treatment with Various Amounts of Water and a Long (6 h) Heating Time $30.00 $60.00 Add to Cart ASTM B401-12(2016) Standard Specification for Compact Round Concentric-Lay-Stranded Aluminum Conductors, Steel-Reinforced (ACSR/COMP) $32.00 $64.00 Add to Cart ASTM C181-91(1997)e1 Standard Test Method for Workability Index of Fireclay and High-Alumina Plastic Refractories $25.00 $50.00 Add to Cart ASTM E1114-92(1997)e1 Standard Test Method for Determining the Focal Size of Iridium-192 Industrial Radiographic Sources $25.00 $50.00 Add to Cart