• ASTM B250/B250M-07

ASTM B250/B250M-07

Standard Specification for General Requirements for Wrought Copper Alloy Wire

ASTM International, 10/01/2007

Publisher: ASTM

File Format: PDF

$30.00$60.00


Published:01/10/2007

Pages:9

File Size:1 file , 130 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification establishes requirements common to wrought copper and copper alloy wire and shall apply to Specifications B 16/B 16M, B 99/B 99M, B 134/B 134M, B 159/B 159M, B 197/B 197M, B 206/B 206M, B 272, B 301/B 301M and B 453/B 453M to the extent referenced therein.

1.2 The chemical composition, physical and mechanical properties, and all other requirements not included in this specification shall be prescribed in the product specification.

1.3 The following safety hazard caveat pertains only to the test methods described in this specification.

1.3.1 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.

1.4 UnitsValues stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

More ASTM standard pdf

ASTM D7060-20

ASTM D7060-20

Standard Test Method for Determination of the Maximum Flocculation Ratio and Peptizing Power in Residual and Heavy Fuel Oils (Optical Detection Method)

$28.00 $56.00

ASTM D4175-20ae1

ASTM D4175-20ae1

Standard Terminology Relating to Petroleum Products, Liquid Fuels, and Lubricants

$52.00 $104.00

ASTM F1952-22

ASTM F1952-22

Standard Specification for Helmets Used for Downhill Mountain Bicycle Racing

$24.00 $48.00

ASTM F714-22

ASTM F714-22

Standard Specification for Polyethylene (PE) Plastic Pipe (DR-PR) Based on Outside Diameter

$31.00 $63.00