• ASTM B312-20

ASTM B312-20

Standard Test Method for Green Strength of Specimens Compacted from Metal Powders

ASTM International, 04/01/2020

Publisher: ASTM

File Format: PDF

$25.00$50.00


Published:01/04/2020

Pages:6

File Size:1 file , 130 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This standard covers a test method that may be used to measure the transverse rupture strength of a compacted but unsintered (green) test specimen produced from lubricated or unlubricated metal powders or powder mixtures.

1.2 Green strength is measured by a quantitative laboratory procedure in which the fracture strength is calculated from the force required to break an unsintered test specimen supported as a simple beam while subjected to a uniformly increasing three-point transverse load under controlled conditions.

1.3 This test method is a companion standard to Test Method B528 that covers the measurement of the transverse rupture strength of sintered PM test specimens.

1.4 Units-With the exception of the values for density and the mass used to determine density, for which the use of the gram per cubic centimeter (g/cm³) and gram (g) units is the longstanding industry practice, the values in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM D3228-22

ASTM D3228-22

Standard Test Method for Total Nitrogen in Lubricating Oils and Fuel Oils by Modified Kjeldahl Method

$28.00 $57.00

ASTM C728-15

ASTM C728-15

Standard Specification for Perlite Thermal Insulation Board

$25.00 $50.00

ASTM C610-05

ASTM C610-05

Standard Specification for Molded Expanded Perlite Block and Pipe Thermal Insulation

$30.00 $60.00

ASTM Volume 05.06:2018

ASTM Volume 05.06:2018

ASTM Book of Standards Volume 05.06 Gaseous Fuels; Coal and Coke; Catalysts; Bioenergy and Industrial Chemicals from Biomass

$145.00 $291.00