• ASTM B327-98e1

ASTM B327-98e1

Standard Specification for Master Alloys Used in Making Zinc Die Casting Alloys

ASTM International, 01/01/1998

Publisher: ASTM

File Format: PDF

$25.00$50.00


Published:01/01/1998

Pages:3

File Size:1 file , 22 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification covers aluminum-base and zinc-base master alloys used to make zinc die-casting alloys. Alloy compositions specified for aluminum-base master alloys (hardeners) are designated as shown in Table 1. Alloy composition specified for the zinc-base master alloy is designated as shown in Table 2.

1.2 Aluminum alloy hardeners are added to Special High Grade zinc (per Specification B6) in the proper alloying ratios, as shown in Table 1 , to produce zinc alloys for die casting.

1.3 Zinc-base master alloy is added to Special High Grade zinc (per Specification B6) in the proper alloying ratio, as shown in Table 3, to produce zinc alloy for die casting.

1.4 Master alloys may be supplied in the form of shot, bar, ingot or jumbo ingot as specified by the purchaser.

1.5 The values stated in inch-pound units are standard. The SI equivalents of inch-pound units are for information only.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Data Sheet for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.

More ASTM standard pdf

ASTM D976-91(1995)e1

ASTM D976-91(1995)e1

Standard Test Methods for Calculated Cetane Index of Distillate Fuels

$26.00 $52.00

ASTM A82/A82M-05a

ASTM A82/A82M-05a

Standard Specification for Steel Wire, Plain, for Concrete Reinforcement

$30.00 $60.00

ASTM D6709-10

ASTM D6709-10

Standard Test Method for Evaluation of Automotive Engine Oils in the Sequence VIII Spark-Ignition Engine (CLR Oil Test Engine)

$43.00 $86.00

ASTM A690/A690M-00a

ASTM A690/A690M-00a

Standard Specification for High-Strength Low-Alloy Steel H-Piles and Sheet Piling for Use in Marine Environments

$25.00 $50.00