Your shopping cart is empty!
ASTM International, 11/01/2009
Publisher: ASTM
File Format: PDF
$30.00$60.00
Published:01/11/2009
Pages:7
File Size:1 file , 130 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers the requirements for rod drawing stock in diameters from ¼ to 1³/8 in. (6.4 to 35 mm) produced from electrolytic tough-pitch or oxygen-free coppers and are suitable for further fabrication into electrical conductors.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 The following safety hazards caveat pertains only to Section 13. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Practice for Characterizing Neutron Fluence Spectra in Terms of an Equivalent Monoenergetic Neutron Fluence for Radiation-Hardness Testing of Electronics
$36.00 $72.00
Standard Test Method for Amyl Nitrate in Diesel Fuels
$26.00 $52.00
Standard Guide for Use of Adhesive-Bonded Single Lap-Joint Specimen Test Results
$24.00 $48.00
Standard Test Method to Evaluate Edge Binding Components Used in Mattresses After Exposure to An Open Flame
$30.00 $60.00