Your shopping cart is empty!
ASTM International, 04/01/2004
Publisher: ASTM
File Format: PDF
$26.00$52.00
Published:01/04/2004
Pages:4
File Size:1 file , 54 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method gives two procedures for measuring the force required to peel a metallic coating from a plastic substrate. One procedure (Procedure A) utilizes a universal testing machine and yields reproducible measurements that can be used in research and development, in quality control and product acceptance, in the description of material and process characteristics, and in communications. The other procedure (Procedure B) utilizes an indicating force instrument that is less accurate and that is sensitive to operator technique. It is suitable for process control use.
1.2 The tests are performed on standard molded plaques. This method does not cover the testing of production electroplated parts.
1.3 The tests do not necessarily measure the adhesion of a metallic coating to a plastic substrate because in properly prepared test specimens, separation usually occurs in the plastic just beneath the coating-substrate interface rather than at the interface. It does, however, reflect the degree that the process is controlled.
1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Specification for Fuel Oils
$30.00 $60.00
Standard Test Method for Autogenous Ignition Temperature of Liquids and Solids in a High-Pressure Oxygen-Enriched Environment
$29.00 $58.00
Standard Test Methods of Sampling and Testing Pulps to be Used in the Manufacture of Electrical Insulation
Standard Practice for Preparation of Insulating Paper and Board Impregnated with a Liquid Dielectric
$26.00 $52.00