Your shopping cart is empty!
ASTM International, 05/01/2016
Publisher: ASTM
File Format: PDF
$29.00$58.00
Published:01/05/2016
Pages:6
File Size:1 file , 110 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification contains various requirements that, with the exception of Section 5 and Section 10, are mandatory requirements to the following ASTM nickel and nickel alloy, longitudinally welded piping specifications:2
Title of Specification
ASTM Designation2
Welded UNS N08020 Alloy Pipe
B464/B464M
Welded Nickel-Iron-Chromium Alloy Pipe
B514
Welded Nickel-Chromium-Iron-Alloy (UNS N06600, UNS N06603, UNS N06025 and UNS N06045) Pipe
B517
Welded Nickel and Nickel-Cobalt Alloy Pipe
B619/B619M
UNS N08904, UNS N08925, and UNS N08926 Welded Pipe
B673
UNS N08367 Welded Pipe
B675
Nickel-Alloy (UNS N06625, N06219, and N08825) Welded Pipe
B705
Ni-Cr-Mo-Co-W-Fe-Si Alloy (UNS N06333) Welded Pipe
B723
Welded Nickel (UNS N02200/UNS N02201) and Nickel Copper Alloy (UNS N04400) Pipe
B725
1.2 One or more of the test requirements of Section 5 apply only if specifically stated in the product specification or in the purchase order.
1.3 In case of conflict between a requirement of the product specification and a requirement of this general specification, only the requirement of the product specification needs to be satisfied.
1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Safety Data Sheet (SDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.
Standard Test Method for Evaluation of Load-Carrying Capacity of Lubricants Under Conditions of Low Speed and High Torque Used for Final Hypoid Drive Axles
$33.00 $67.00
Standard Specification for Design of the Command and Control System for Small Unmanned Aircraft Systems (sUAS)
$34.00 $68.00
Standard Guide for Metals Identification, Grade Verification, and Sorting
$38.00 $76.00
Standard Specification for UNS N08925, UNS N08354, and UNS N08926 Seamless Pipe and Tube
$26.00 $52.00