Your shopping cart is empty!
ASTM International, 03/01/2018
Publisher: ASTM
File Format: PDF
$30.00$60.00
Published:01/03/2018
Pages:7
File Size:1 file , 98 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers seamless copper water tube suitable for general plumbing, similar applications for the conveyance of fluids, and commonly used with solder, flared, or compression-type fittings. The type of copper water tube suitable for any particular application is determined by the internal or external fluid pressure, by the installation and service conditions, and by local requirements. Means of joining or bending are also factors that affect the selection of the type of tube to be used.2
Note 1: Annealed tube is suitable for use with flared or compression fittings, and with solder-type fittings, provided rounding and sizing of the tube ends is performed where needed.
Note 2: Drawn temper tube is suitable for use with solder-type fittings. Types A and B tube, in the drawn temper, are suitable for use with certain types and sizes of compression fittings.
1.2 The tube shall be produced from the following coppers, and the manufacturer has the option to supply any one of them, unless otherwise specified:
Copper UNS No.
Previously Used Designation
Description
C10200
OF
Oxygen free without residual deoxidants
C12000
DLP
Phosphorus deoxidized, low residual phosphorus
C12200
DHP
Phosphorus deoxidized, high residual phosphorus
1.3 The assembly of copper plumbing or fire sprinkler systems by soldering is described in Practice B828.
1.4 Solders for joining copper potable water or fire sprinkler systems are covered by Specification B32. The requirements for acceptable fluxes for these systems are covered by Specification B813.
1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
Note 3: This specification is the SI companion to Specification B88.
1.6 The following safety hazards caveat pertains only to the test methods portion, Section 15, of this specification: This standard does not purport to address all of
Standard Guide for Testing Filiform Corrosion Resistance of Organic Coatings on Metal
$26.00 $52.00
Standard Classification for Sizes of Aggregate for Road and Bridge Construction
Standard Test Method for Measurement of Fuel System Icing Inhibitors (Ether Type) in Aviation Fuels
Standard Specification for Ventilators Intended for Use During Anesthesia (Withdrawn 2012)
$32.00 $65.00
