Your shopping cart is empty!
ASTM International, 12/15/2012
Publisher: ASTM
File Format: PDF
$30.00$60.00
Published:15/12/2012
Pages:10
File Size:1 file , 140 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method covers determination of the compressive strength of hydraulic cement mortars, using 2-in. or [50-mm] cube specimens.
1.2 This test method covers the application of the test using either inch-pound or SI units. The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
1.3 Values in SI units shall be obtained by measurement in SI units or by appropriate conversion, using the Rules for Conversion and Rounding given in Standard IEEE/ASTM SI-10, of measurements made in other units.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. (Warning-Fresh hydraulic cementitious mixtures are caustic and may cause chemical burns to skin and tissue upon prolonged exposure.2)
Standard Test Method for Lead and Cadmium Extracted from Glazed Ceramic Tile
$26.00 $52.00
Standard Specification for High Voltage Detectors - ;Part 1 Capacitive Type to be Used for Voltages Exceeding 600 Volts AC
$29.00 $58.00
Standard Specification for General Requirements for Rolled Structural Steel Bars, Plates, Shapes, and Sheet Piling
$50.00 $101.00
Standard Practice for Sample Preparation of Transparent Plastic Films for Specular Gloss Measurements, on Membrane Switch Overlays
$25.00 $50.00
