Your shopping cart is empty!
ASTM International, 07/14/2021
Publisher: ASTM
File Format: PDF
$30.00$60.00
Published:14/07/2021
Pages:12
File Size:1 file , 150 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1''This test method covers determination of the compressive strength of hydraulic cement mortars, using 2-in. or [50''mm] cube specimens.
Note 1:''Test Method C349 provides an alternative procedure for this determination (not to be used for acceptance tests).
1.2''This test method covers the application of the test using either inch-pound or SI units. The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
1.3''Values in SI units shall be obtained by measurement in SI units or by appropriate conversion, using the Rules for Conversion and Rounding given in IEEE/ASTM SI-10, of measurements made in other units.
1.4''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. (Warning'''Fresh hydraulic cementitious mixtures are caustic and may cause chemical burns to skin and tissue upon prolonged exposure.2)
1.5''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Test Method for Measurement of Extreme-Pressure Properties of Lubricating Fluids (Timken Method)
$32.00 $65.00
Standard Specification for Zirconium and Zirconium Alloy Strip, Sheet, and Plate
$30.00 $60.00
Standard Test Method for Compositional Analysis by Thermogravimetry
Standard Specification for Unalloyed Magnesium Ingot and Stick For Remelting
$26.00 $52.00