• ASTM C1113/C1113M-09

ASTM C1113/C1113M-09

Standard Test Method for Thermal Conductivity of Refractories by Hot Wire (Platinum Resistance Thermometer Technique)

ASTM International, 03/01/2009

Publisher: ASTM

File Format: PDF

$30.00$60.00


Published:01/03/2009

Pages:6

File Size:1 file , 110 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers the determination of thermal conductivity of non-carbonacious, dielectric refractories.

1.2 Applicable refractories include refractory brick, refractory castables, plastic refractories, ramming mixes, powdered materials, granular materials, and refractory fibers.

1.3 Thermal conductivity k-values can be determined from room temperature to 1500°C [2732°F], or the maximum service limit of the refractory, or to the temperature at which the refractory is no longer dielectric.

1.4 This test method is applicable to refractories with k-values less than 15 W/m·K [100 Btu·in./h·ft²·°F].

1.5 In general it is difficult to make accurate measurements of anisotropic materials, particularly those containing fibers, and the use of this test method for such materials should be agreed between the parties concerned.

1.6 Units - The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.7 This standard does not purport to address the safety concerns, if any, associated with it's use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

More ASTM standard pdf

ASTM E1155-20

ASTM E1155-20

Standard Test Method for Determining FF Floor Flatness and FL Floor Levelness Numbers

$25.00 $50.00

ASTM E927-19

ASTM E927-19

Standard Classification for Solar Simulators for Electrical Performance Testing of Photovoltaic Devices

$24.00 $48.00

ASTM D2281-10(2016)

ASTM D2281-10(2016)

Standard Test Method for Evaluation of Wetting Agents by the Skein Test

$21.00 $42.00

ASTM B941-16

ASTM B941-16

Standard Specification for Heat Resistant Aluminum-Zirconium Alloy Wire for Electrical Purposes

$30.00 $60.00