Your shopping cart is empty!
ASTM International, 06/01/2009
Publisher: ASTM
File Format: PDF
$30.00$60.00
Published:01/06/2009
Pages:6
File Size:1 file , 110 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method covers the determination of the average compressive stress in existing unreinforced solid-unit masonry (see Note 1). This test method concerns the measurement of in-situ compressive stress in existing masonry by use of thin, bladder-like flatjack devices that are installed in saw cut mortar joints in the masonry wall. This test method provides a relatively non-destructive means of determining masonry properties in place.
Note 1 - Solid-unit masonry is that built with stone, concrete, or clay units whose net area is equal to or greater than 75 % of the gross area.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Guide for Selection, Design, and Installation of Thermoplastic Water- Pressure Piping Systems
$32.00 $65.00
Standard Specification for Copper Flat Products with Finished (Rolled or Drawn) Edges (Flat Wire and Strip)
$30.00 $60.00
Standard Guide for Metallographic Sample Preparation of Cemented Tungsten Carbides
$26.00 $52.00
Standard Practice for Preparing Coal Samples for Analysis
$27.00 $54.00