• ASTM C1244-11(2017)

ASTM C1244-11(2017)

Standard Test Method for Concrete Sewer Manholes by the Negative Air Pressure (Vacuum) Test Prior to Backfill

ASTM International, 04/01/2017

Publisher: ASTM

File Format: PDF

$27.00$54.00


Published:01/04/2017

Pages:4

File Size:1 file , 68 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers procedures for testing precast concrete manhole sections when using the vacuum test method to demonstrate the integrity of the installed materials and the construction procedures. This test method is used for testing concrete manhole sections utilizing mortar, mastic, or gasketed joints.

1.2 This test method is intended to be used as a preliminary test to enable the installer to demonstrate the condition of the concrete manholes prior to backfill. Users are hereby cautioned that misuse or misapplication of the test criteria contained herein can cause permanent damage to the system being tested.

Note 1: Vacuum test criteria presented in this test method are similar to those in general use. The test and criteria have been widely and successfully used in testing manholes.

Note 2: The user of this test method is advised that no correlation has been found between vacuum (air) and hydrostatic tests.

1.3 This test method is the companion to metric Test Method C1244M; therefore, no SI equivalents are shown in this test method.

1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM D1630-16

ASTM D1630-16

Standard Test Method for Rubber Property-Abrasion Resistance (Footwear Abrader)

$31.00 $62.00

ASTM D7450-13

ASTM D7450-13

Standard Specification for Performance of Rear Axle Gear Lubricants Intended for API Category GL-5 Service

$26.00 $52.00

ASTM D7467-19

ASTM D7467-19

Standard Specification for Diesel Fuel Oil, Biodiesel Blend (B6 to B20)

$43.00 $86.00

ASTM E256-09

ASTM E256-09

Standard Test Method for Chlorine in Organic Compounds by Sodium Peroxide Bomb Ignition (Withdrawn 2018)

$26.00 $52.00