Your shopping cart is empty!
ASTM International, 10/01/2009
Publisher: ASTM
File Format: PDF
$30.00$60.00
Published:01/10/2009
Pages:7
File Size:1 file , 170 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method covers the determination of edge stresses and surface stresses in annealed, heat-strengthened, and fully tempered flat glass products.
1.2 This test method is non-destructive.
1.3 This test method uses transmitted light and is, therefore, applicable to light-transmitting glasses.
1.4 The test method is not applicable to chemically-tempered glass.
1.5 Using the procedure described, surface stresses can be measured only on the "tin" side of float glass.
1.6 Surface-stress measuring instruments are designed for a specific range of surface index of refraction.
1.7 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.8 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Specification for Metric-sized Crosslinked Polyethylene (PEX) Pipe
$32.00 $65.00
Standard Test Method for Storage Modulus Calibration of Dynamic Mechanical Analyzers
$25.00 $50.00
Standard Guide for Direct-Push Groundwater Sampling for Environmental Site Characterization
$34.00 $69.00
Standard Practice for Applying Coil Coatings Using The Wire-Wound Drawdown Bar
$26.00 $52.00