• ASTM C1365-06(2011)

ASTM C1365-06(2011)

Standard Test Method for Determination of the Proportion of Phases in Portland Cement and Portland-Cement Clinker Using X-Ray Powder Diffraction Analysis

ASTM International, 12/01/2011

Publisher: ASTM

File Format: PDF

$30.00$60.00


Published:01/12/2011

Pages:10

File Size:1 file , 150 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers direct determination of the proportion by mass of individual phases in portland cement or portland-cement clinker using quantitative X-ray (QXRD) analysis. The following phases are covered by this standard: alite (tricalcium silicate), belite (dicalcium silicate), aluminate (tricalcium aluminate), ferrite (tetracalcium aluminoferrite), periclase (magnesium oxide), gypsum (calcium sulfate dihydrate), bassanite (calcium sulfate hemihydrate), anhydrite (calcium sulfate), and calcite (calcium carbonate).

1.2 This test method specifies certain general aspects of the analytical procedure, but does not specify detailed aspects. Recommended procedures are described, but not specified. Regardless of the procedure selected, the user shall demonstrate by analysis of certified reference materials (CRM's) that the particular analytical procedure selected for this purpose qualifies (that is, provides acceptable precision and bias) (see Note 1). The recommended procedures are ones used in the round-robin analyses to determine the precision levels of this test method.

Note 1 - A similar approach was used in the performance requirements for alternative methods for chemical analysis in Test Methods C114.

1.3 The values stated in SI units shall be regarded as the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazards, see Section 9.

More ASTM standard pdf

ASTM B873-21

ASTM B873-21

Standard Test Method for Measuring Volume of Apparent Density Cup Used in Test Methods B212, B329, and B417

$30.00 $60.00

ASTM B812-18

ASTM B812-18

Standard Test Method for Resistance to Environmental Degradation of Electrical Pressure Connections Involving Aluminum and Intended for Residential Applications

$31.00 $63.00

ASTM D7482-17

ASTM D7482-17

Standard Practice for Sampling, Storage, and Handling of Hydrocarbons for Mercury Analysis

$34.00 $68.00

ASTM F945-12(2019)

ASTM F945-12(2019)

Standard Test Method for Stress-Corrosion of Titanium Alloys by Aircraft Engine Cleaning Materials

$32.00 $64.00