Your shopping cart is empty!
ASTM International, 06/01/2022
Publisher: ASTM
File Format: PDF
$30.00$60.00
Published:01/06/2022
Pages:11
File Size:1 file , 430 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1''This test method covers procedures for determining the thickness of concrete slabs, pavements, bridge decks, walls, or other plate-like structure using the impact-echo method.
1.2''The following two procedures are covered in this test method:
1.2.1''Procedure A: P-Wave Speed Measurement'''This procedure measures the time it takes for the P-wave generated by a short-duration, point impact to travel between two transducers positioned a known distance apart along the surface of a structure. The P-wave speed is calculated by dividing the distance between the two transducers by the travel time.
1.2.2''Procedure B: Impact-Echo Test'''This procedure measures the frequency at which the P-wave generated by a short-duration, point impact is reflected between the parallel (opposite) surfaces of a plate. The thickness is calculated from this measured frequency and the P-wave speed obtained from Procedure A.
1.2.3''Unless specified otherwise, both Procedure A and Procedure B must be performed at each point where a thickness determination is made.
1.3''The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4''The text of this standard references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.
1.5''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Test Method for Adhesion and Cohesion of One-Part Elastomeric Solvent Release Sealants
$28.00 $57.00
Standard Practice for Evaluating Stress-Corrosion Cracking Resistance of Low Copper 7XXX Series Al-Zn-Mg-Cu Alloys in Boiling 6 % Sodium Chloride Solution
$25.00 $50.00
Standard Test Method for Determining Ignition Temperature of Plastics
Standard Guide for Use of Standard Test Methods and Practices for Evaluating Antibacterial Activity on Textiles
