• Your shopping cart is empty!

  • ASTM C148-14

ASTM C148-14

Standard Test Methods for Polariscopic Examination of Glass Containers

ASTM International, 05/01/2014

Publisher: ASTM

File Format: PDF

$26.00$52.00


Published:01/05/2014

Pages:4

File Size:1 file , 72 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 These test methods describe the determination of relative optical retardation associated with the state of anneal of glass containers. Two alternative test methods are covered as follows:

 

Sections

 

 

Test Method A-Comparison with Reference
 Standards Using a Polariscope

6 to 9

Test Method B-Determination with Polarimeter

10 to 12

1.2 Test Method A is useful in determining retardations less than 150 nm, while Test Method B is useful in determining retardations less than 565 nm.

Note 1-The apparent temper number as determined by these test methods depends primarily on (1) the magnitude and distribution of the residual stress in the glass, (2) the thickness of the glass (optical path length at the point of grading), and ( 3) the composition of the glass. For all usual soda-lime silica bottle glass compositions, the effect of the composition is negligible. In an examination of the bottom of a container, the thickness of glass may be taken into account by use of the following formula, which defines a real temper number, TR, in terms of the apparent temper number, TA, and the bottom thickness, t:

T R = TA (0.160/t)
where t is in inches, or
TR = TA (4.06/t)

where t is in millimetres.
This thickness should be measured at the location of the maximum apparent retardation. Interpretation of either real or apparent temper number requires practical experience with the particular ware being evaluated.

1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

More ASTM standard pdf

ASTM D5923-96e1

ASTM D5923-96e1

Standard Guide for Selection of Kriging Methods in Geostatistical Site Investigations

$25.00 $50.00

ASTM G126-16

ASTM G126-16

Standard Terminology Relating to the Compatibility and Sensitivity of Materials in Oxygen Enriched Atmospheres

$34.00 $68.00

ASTM D1938-14

ASTM D1938-14

Standard Test Method for Tear-Propagation Resistance (Trouser Tear) of Plastic Film and Thin Sheeting by a Single-Tear Method

$25.00 $50.00

ASTM C425-04

ASTM C425-04

Standard Specification for Compression Joints for Vitrified Clay Pipe and Fittings

$26.00 $52.00