Your shopping cart is empty!
ASTM International, 08/01/2017
Publisher: ASTM
File Format: PDF
$29.00$58.00
Published:01/08/2017
Pages:10
File Size:1 file , 150 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 These test methods cover procedures for sampling and testing fly ash and raw or calcined pozzolans for use in portland-cement concrete.
1.2 The procedures appear in the following order:
Sections
Sampling
7
CHEMICAL ANALYSIS
Reagents and apparatus
10
Moisture content
11 and 12
Loss on ignition
13 and 14
Silicon dioxide, aluminum oxide, iron oxide, calcium oxide, magnesium oxide, sulfur trioxide, sodium oxide and potassium oxide
15
Available alkali
16 and 17
Ammonia
18
PHYSICAL TESTS
Density
19
Fineness
20
Increase of drying shrinkage of mortar bars
21 - 23
Soundness
24
Air-entrainment of mortar
25 and 26
Strength activity index with portland cement
27 - 30
Water requirement
31
Effectiveness of Fly Ash or Natural Pozzolan in Controlling Alkali-Silica Reactions
32
Effectiveness of Fly Ash or Natural Pozzolan in Contributing to Sulfate Resistance
34
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
Note 1: Sieve size is identified by its standard designation in Specification E11. The alternative designation given in parentheses is for information only and does not represent a different standard sieve size.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.5 The text of this standard references notes and footnotes that provide explanatory information. These notes and footnotes (excluding those in tables) shall not be considered as requirements of this standard.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Guide for Functional, Kinematic, and Wear Assessment of Total Disc Prostheses
$26.00 $52.00
ASTM Book of Standards - Section 9 - Rubber (Vols 09.01-09.02)
$126.00 $252.26
Standard Test Method for Whole Boot Breathability (MVTR)
$24.00 $48.00
Standard Test Method for Blocking
$25.00 $50.00
