• Your shopping cart is empty!

  • ASTM C330/C330M-23

ASTM C330/C330M-23

Standard Specification for Lightweight Aggregates for Structural Concrete

ASTM International, 06/01/2023

Publisher: ASTM

File Format: PDF

$25.00$50.00


Published:01/06/2023

Pages:4

File Size:1 file , 280 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification covers lightweight aggregates intended for use in structural concrete in which prime considerations are reducing the density while maintaining the compressive strength of the concrete. Procedures covered in this specification are not intended for job control of concrete.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.2.1 With regard to other units of measure, the values stated in inch-pound units are to be regarded as standard.
1.3 The text of this specification references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.
Note 1: This specification is regarded as adequate to ensure satisfactory lightweight aggregates for most concrete. It is recognized that it may be either more or less restrictive than needed for some conditions and for special purposes, such as fire resistance, fill, and concrete constructions, the use of which is based on load tests rather than conventional design procedures.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM D429-02a

ASTM D429-02a

Standard Test Methods for Rubber Property - ;Adhesion to Rigid Substrates

$33.00 $67.00

ASTM F1536-95(2015)

ASTM F1536-95(2015)

Standard Test Method for Determining Strength and Setting Time of Synthetic Water-Activated Polyurethane Fiberglass Orthopaedic Casting Tape

$29.00 $58.00

ASTM D5869-95(2002)

ASTM D5869-95(2002)

Standard Practice for Dark Oven Heat Exposure of Bituminous Materials

$26.00 $52.00

ASTM A354-17e2

ASTM A354-17e2

Standard Specification for Quenched and Tempered Alloy Steel Bolts, Studs, and Other Externally Threaded Fasteners

$24.00 $48.00