• ASTM C428/C428M-05(2019)

ASTM C428/C428M-05(2019)

Standard Specification for Asbestos-Cement Nonpressure Sewer Pipe (Withdrawn 2022)

ASTM International, 04/15/2019

Publisher: ASTM

File Format: PDF

$32.00$64.00


Published:15/04/2019

Pages:5

File Size:1 file , 88 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification covers requirements relating to asbestos-cement nonpressure sewer pipe, joints, and fittings suitable for use with gravity flow, intended for sewerage and drainage applications from point of use to point of treatment or disposal. It defines certain conditions of manufacture, classification, characteristics, and acceptance tests applicable to these products.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

Note 1: Rubber rings suitable for use with this pipe are covered in Specification D1869.

Note 2: As general guidance to achieve safe and clean construction-site conditions when working with asbestos-cement pipe products, the procedures covered in AWWA No. M-16 shall be followed.

Note 3: This specification is issued for product standardization and purchasing purposes only, and does not include requirements for installation or the relationships between operating conditions and the strength characteristics of the various classifications of pipe. The purchaser is cautioned that he must correlate installation and operating conditions with the specified characteristics of the pipe.

1.3 Warning-Breathing of asbestos dust is hazardous. Asbestos and asbestos products present demonstrated health risks for users and for those with whom they come into contact. In addition to other precautions, when working with asbestos-cement products minimize the dust that results. For information on the safe use of chrysoltile asbestos, refer to “Safe Use of Chrysotile: A Manual on Preventive and Control Measures.”2

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For a specific safety hazard, see 1.3.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM D8111-21a

ASTM D8111-21a

Standard Test Method for Evaluation of Automotive Engine Oils in the Sequence IIIH, Spark-Ignition Engine

$41.00 $82.00

ASTM D5964-16

ASTM D5964-16

Standard Practice for Rubber IRM 901, IRM 902, and IRM 903 Replacement Oils for ASTM No. 1, ASTM No. 2, ASTM No. 3 Oils, and IRM 905 formerly ASTM No. 5 Oil

$31.00 $62.00

ASTM F3174/F3174M-15

ASTM F3174/F3174M-15

Standard Specification for Establishing Operating Limitations and Information for Aeroplanes

$25.00 $50.00

ASTM E1316-21a

ASTM E1316-21a

Standard Terminology for Nondestructive Examinations

$44.00 $89.00