Your shopping cart is empty!
ASTM International, 01/01/2016
Publisher: ASTM
File Format: PDF
$32.00$65.00
Published:01/01/2016
Pages:15
File Size:1 file , 190 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 These test methods cover the chemical analysis of gypsum and gypsum panel products, including gypsum ready-mixed plaster, gypsum wood-fibered plaster, and gypsum concrete.
1.2 The test methods appear in the following order:
Sections
Preparation of Sample
4
Complete Procedure
5 - 16
Alternative Procedure for Analysis of Free Water in Gypsum Using a Moisture Balance
17
Alternative Procedure for Analysis of Combined Water in Gypsum Using a Moisture Balance
18
Alternative Procedure for Analysis for Calcium Sulfate by Ammonium Acetate Method
19
Alternative Procedure for Analysis for Sodium Chloride by the Coulometric Method
20
Determination of Sand in Set Plaster
21
Wood-Fiber Content in Wood-Fiber Gypsum Plaster
22
Optional Procedure for Analysis for Sodium by the Atomic Absorption Method
23
Optional Procedure for Analysis for Sodium by Flame Photometry
24
Determination of Orthorhombic Cyclooctasulfur (S8) in Ggypsum Panel Products-General Provisions
25
Determination of Orthorhombic Cyclooctasulfur (S8) in Gypsum Panel Products by Gas Chromatograph Equipped with a Mass Spectrometer (GS/MS)
26
Determination of Orthorhombic Cyclooctasulfur (S8) in Gypsum Panel Products by Gas Chromatograph Equipped with an Electron Capture Detector (GC/ECD)
27
Determination of Orthorhombic Cyclooctasulfur (S8) in Gypsum Panel Products by High-performance Liquid Chromatograph Equipped with and Ultraviolet Detector (HPLC/UV)
28
1.3 The text of this standard references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.
1.4 The values stated in SI units are to be regarded as the standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Practice for Determining Safe Current Pulse-Operating Regions for Metallization on Semiconductor Components [Metric]
$29.00 $58.00
Standard Test Method for Determining Current Carrying Capacity of a Conductor as Part of a Membrane Switch Circuit
$25.00 $50.00
Standard Practice for Micrometer Bend Test for Ductility of Electrodeposits
$26.00 $52.00
Standard Specification for Steel Castings, Surface Acceptance Standards, Magnetic Particle and Liquid Penetrant Inspection
