Your shopping cart is empty!
ASTM International, 01/01/2018
Publisher: ASTM
File Format: PDF
$29.00$58.00
Published:01/01/2018
Pages:9
File Size:1 file , 110 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers the manufacture and purchase requirements of products used for the assembly and construction of circular vertical precast reinforced concrete manholes and structures used in sewer, drainage, and water works.
1.2 Part I, Sections 1 - 11, of this specification presents general requirements and requirements which are common to each precast concrete product covered by this specification.
1.3 Part II of this specification presents specific requirements for each manhole product in the following sections:
Product
Section
Grade Rings
12
Flat Slab Tops
13
Risers and Conical Tops
14
Base Sections
15
Steps and Ladders
16
Note 1: Future products will be included in Part II in a future revision of this specification.
1.4 This specification is the SI companion to C478.
Note 2: This specification is a manufacturing and purchase specification only, and does not include requirements for backfill, or the relationship between field load conditions and the strength requirements of the manhole products and appurtenances. Experience has shown, however, that the successful performance of this product depends upon the proper selection of the product strength, type of foundation and backfill, and care in the field installation of the manhole products and connecting pipes. The owner of the project for which these products are specified herein is cautioned to require inspection at the construction site.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Test Method for Dry Abrasion Resistance of Hydrophobic and Omniphobic Coatings
$26.00 $52.00
Standard Practice for Ultrasonic Testing of the Weld Zone of Welded Pipe and Tubing
Standard Practice for Basic Functional Stability of a Mechanical Pump Dispenser
$21.00 $42.00
Standard Guide for Selection and Procurement of Protective Gloves Worn by Law Enforcement and Corrections
$27.00 $54.00
