Your shopping cart is empty!
ASTM International, 08/01/2012
Publisher: ASTM
File Format: PDF
$26.00$52.00
Published:01/08/2012
Pages:3
File Size:1 file , 65 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method covers the measurement of the linear shrinkage during setting and curing and the coefficient of thermal expansion of chemical-resistant mortars, grouts, monolithic surfacings, and polymer concretes.
1.2 A bar of square cross-section is cast to a prescribed length in a mold that holds measuring studs that are captured in the ends of the finished casting.
1.2.1 The change in length after curing is measured and used to calculate shrinkage.
1.2.2 The change in length at a specific elevated temperature is measured and used to calculate the coefficient of thermal expansion.
1.3 This test method is limited to materials with aggregate size of 0.25 in. (6 mm) or less.
1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Terminology Relating to Materials for Roads and Pavements
$29.00 $58.00
Standard Test Method for Critical Radiant Flux of Floor-Covering Systems Using a Radiant Heat Energy Source
$28.00 $56.00
Standard Practice for Obtaining Spectroradiometric Data from Radiant Sources for Colorimetry
Standard Test Method for Determining Ignition Temperature of Plastics
$30.00 $60.00
