• ASTM C541/C541M-98(2019)

ASTM C541/C541M-98(2019)

Standard Specification for Linings for Asbestos-Cement Pipe (Withdrawn 2022)

ASTM International, 04/15/2019

Publisher: ASTM

File Format: PDF

$28.00$56.00


Published:15/04/2019

Pages:3

File Size:1 file , 69 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification covers requirements for plastic linings to be applied to asbestos-cement pipe, designed for special service in carrying corrosive fluids. This specification also covers methods of testing plastic lining material as well as sections of lined pipe. The requirements established by this specification shall serve as a guide in, but not the sole basis for, judging the suitability of the product for a particular service. The selection of the material should include consideration of performance in similar applications or testing under the intended service condition.

Note 1: To determine the suitability of the product for a particular service or corrosive fluid, refer to the manufacturer for specific recommendations.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 Warning-Breathing of asbestos dust is hazardous. Asbestos and asbestos products present demonstrated health risks for users and for those with whom they come into contact. In addition to other precautions, when working with asbestos-cement products, minimize the dust that results. For information on the safe use of chrysotile asbestos, refer to “Safe Use of Chrysotile: A Manual on Preventive and Control Measures.”2

1.4 The following precautionary caveat pertains only to the test method portion, Section 9, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM D3194-04

ASTM D3194-04

Standard Test Method for Rubber From Natural Sources-Plasticity Retention Index (PRI)

$26.00 $52.00

ASTM E2593-07e1

ASTM E2593-07e1

Standard Guide for Accuracy Verification of Industrial Platinum Resistance Thermometers

$32.00 $65.00

ASTM E2847-14

ASTM E2847-14

Standard Test Method for Calibration and Accuracy Verification of Wideband Infrared Thermometers

$36.00 $72.00

ASTM C375-58(2016)

ASTM C375-58(2016)

Standard Classification of Water Used in Milling of Porcelain Enamel

$28.00 $56.00