• ASTM C563-18a

ASTM C563-18a

Standard Guide for Approximation of Optimum SO3 in Hydraulic Cement

ASTM International, 12/01/2018

Publisher: ASTM

File Format: PDF

$30.00$60.00


Published:01/12/2018

Pages:9

File Size:1 file , 180 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This guide describes the determination of approximate optimum SO3 for maximum performance as a result of substituting calcium sulfate for a portion of the cement.

1.2 This guide refers to the sulfur trioxide (SO3) content of the cement only. Slag cements and occasionally other hydraulic cements can contain sulfide or other forms of sulfur. The determination of SO3 content by rapid methods may include these other forms, and may therefore produce a significant error. If a significant error occurs, analyze the cement for SO3 content using the reference test method of Test Methods C114 for sulfur trioxide.

1.3 Values stated as SI units are to be regarded as standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM D7945-21

ASTM D7945-21

Standard Test Method for Determination of Dynamic Viscosity and Derived Kinematic Viscosity of Liquids by Constant Pressure Viscometer

$32.00 $64.00

ASTM D5374-22a

ASTM D5374-22a

Standard Test Methods for Forced-Convection Laboratory Ovens for Evaluation of Electrical Insulation

$25.00 $50.00

ASTM E2257-22

ASTM E2257-22

Standard Test Method for Room Fire Test of Wall and Ceiling Materials and Assemblies

$30.00 $60.00

ASTM F1804-08(2020)

ASTM F1804-08(2020)

Standard Practice for Determining Allowable Tensile Load for Polyethylene (PE) Gas Pipe During Pull-In Installation

$27.00 $54.00