Your shopping cart is empty!
ASTM International, 10/15/2012
Publisher: ASTM
File Format: PDF
$30.00$60.00
Published:15/10/2012
Pages:5
File Size:1 file , 95 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers the types, physical properties, and dimensions of unfaced, preformed rigid cellular polyisocyanurate plastic material intended for use as thermal insulation on surfaces from -297??F (-183??C) to 300??F (149??C). For specific applications, the actual temperature limits shall be agreed upon by the manufacturer and purchaser.
1.2 This specification only covers ???polyurethane modified polyisocyanurate??? thermal insulation which is commonly referred to as ???polyisocyanurate??? thermal insulation. This standard does not encompass all polyurethane modified materials. Polyurethane modified polyisocyanurate and other polyurethane materials are similar, but the materials will perform differently under some service conditions.
1.3 This standard is designed as a material specification, not a design document. Physical property requirements vary by application and temperature. At temperatures below -70??F (-51??C) the physical properties of the polyisocyanurate insulation at the service temperature are of particular importance. Below -70??F (-51??C) the manufacturer and the purchaser must agree on what additional cold temperature performance properties are required to determine if the material can function adequately for the particular application.
1.4 This standard addresses requirements of unfaced preformed rigid cellular polyisocyanurate thermal insulation manufactured using blowing agents with an ozone depletion potential of 0 (ODP 0).
1.5 When adopted by an authority having jurisdiction, codes that address fire properties in many applications regulate the use of the thermal insulation materials covered by this specification. Fire properties are controlled by job, project, or other specifications where codes or government regulations do not apply.
1.6 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Specification for Solvent Cements for Styrene-Rubber (SR) Plastic Pipe and Fittings
$21.00 $42.00
Standard Test Method for Bulk Density of Crushed Bituminous Coal
$26.00 $52.00
ASTM Volume 04.06 Thermal Insulation; Building and Environmental Acoustics
$120.00 $241.43
Standard Consumer Safety Specification for Frame Child Carriers
$29.00 $58.00
