Your shopping cart is empty!
ASTM International, 06/01/2017
Publisher: ASTM
File Format: PDF
$30.00$60.00
Published:01/06/2017
Pages:2
File Size:1 file , 59 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers brick made principally from sand and lime and intended for use in brick masonry. Two grades of brick are covered:
1.1.1 Grade SW-Brick intended for use where exposed to temperature below freezing in the presence of moisture.
Note 1: As a typical example, brick used for foundation courses and parapets in the northeastern quarter of the United States should conform to Grade SW.
1.1.2 Grade MW-Brick intended for use where exposed to temperature below freezing but unlikely to be saturated with water.
Note 2: As a typical example, brick exposed in the face of the wall other than parapet or foundations, or brick intended for structures located in regions of the United States characterized by less severe frost action or by drier climate than is found in the northeastern quarter of the United States should conform to Grade MW.
1.1.3 When the term brick is used in this specification, it is understood to mean brick or solid masonry units.
1.2 If brick having a particular color, texture, finish, or uniformity is desired, these features shall be specified separately by the purchaser.
1.3 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.
1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Specification for Reinforced Concrete D-Load Culvert, Storm Drain, and Sewer Pipe (Metric)
$30.00 $60.00
Standard Test Method for Evaluation of Recoverable Stretch of Stretch Yarns (Skein Method)
$25.00 $50.00
ASTM Book of Standards Volume 3.04: Metals Test Methods and Analytical Procedures: Magnetic Properties
$100.00 $200.55
Standard Specification for Pressure Vessel Plates, Carbon Steel, Low- and Intermediate-Tensile Strength
$26.00 $52.00
