Your shopping cart is empty!
ASTM International, 06/01/2015
Publisher: ASTM
File Format: PDF
$25.00$50.00
Published:01/06/2015
Pages:3
File Size:1 file , 71 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification describes the required properties and test methods for a cold liquid-applied elastomeric-type membrane, one- or two-component, for waterproofing building decks and walls subject to hydrostatic pressure in building areas to be occupied by personnel, vehicles, or equipment. This specification applies only to a membrane system that will be covered with a separate wearing course, traffic course, or backfill.
Note 1: See Guide C898 and Guide C1471 for proper application of membrane.
1.2 There are no ISO standards similar or equivalent to this ASTM standard.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Specification for Welded Deformed Steel Bar Mats for Concrete Reinforcement
$23.00 $46.00
Standard Specification for Automotive Spark-Ignition Engine Fuel
$43.00 $86.00
ASTM Volume 4.05: Construction: Chemical-Resistant Nonmetallic Materials; Vitrified Clay Pipe; Concrete Pipe; Fiber-Reinforced Cement Products; Mortars and Grouts; Masonry; Precast Concrete
$102.00 $205.34
Standard Test Method for Coefficient of Kinetic Friction for Wax Coatings
$25.00 $50.00