Your shopping cart is empty!
ASTM International, 11/01/2020
Publisher: ASTM
File Format: PDF
$26.00$52.00
Published:01/11/2020
Pages:7
File Size:1 file , 240 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1''This test method covers the measurement of the compressive stresses (Note 1) developed by fired porcelain enamels using the loaded-beam method.
Note 1:''Although some may interpret the calculations that are used in this test method as indicating compressive load, it is commonly referred to as compressive stress within the porcelain enamel industry.
1.2''This test method is limited to the use of the loaded-beam method. However, this method includes charts (Fig. 1 and Fig. 2) that provide for conversion of loaded-beam test results to warp and ring stress values.
FIG. 2 Conversion Chart for Loaded-Beam Stress to Ring Stress
1.3''The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Specification for Extruded, Compression Molded, and Injection Molded Basic Shapes of Poly(aryl ether ketone) (PAEK)
$30.00 $60.00
Standard Specification for Aluminum and Aluminum-Alloy Extruded Bars, Rods, Wire, Profiles, and Tubes
$33.00 $67.00
Standard Practice for Determining the Performance of Oil/Water Separators Subjected to Surface Run-Off
Standard Test Methods for Estimating Average Particle Size of Alumina and Silica Powders by Air Permeability
$29.00 $58.00
