Your shopping cart is empty!
ASTM International, 10/01/2012
Publisher: ASTM
File Format: PDF
$26.00$52.00
Published:01/10/2012
Pages:2
File Size:1 file , 52 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This practice covers the repair of spray-applied polyurethane insulation on vessels normally operating at temperatures between -30 and+107°C [-22 and +225°F].
1.2 Warning - At temperatures below 0°C [32°F] the application of a spray foam directly onto the cold substrate may not be possible. The term foam applies to spray-applied polyurethane or polyisocyanurate (PUR or PIR) rigid cellular plastic only, and not to any other plastic insulation.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety concerns associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific precautionary statement see 1.2.
Standard Guide for Environmental Compliance Performance Assessment
$41.00 $83.00
Standard Test Method for Semiquantitative Micro Determination of Acid Number of Lubricating Oils During Oxidation Testing
$26.00 $52.00
Standard Test Method for Corrosivity Index of Plastics and Fillers
$25.00 $50.00
Standard Test Method for On-Line Measurement of Turbidity Below 5 NTU in Water (Withdrawn 2023)
$38.00 $76.00
