• ASTM C989/C989M-18a

ASTM C989/C989M-18a

Standard Specification for Slag Cement for Use in Concrete and Mortars

ASTM International, 12/15/2018

Publisher: ASTM

File Format: PDF

$26.00$52.00


Published:15/12/2018

Pages:7

File Size:1 file , 110 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification covers slag cement for use as a cementitious material in concrete and mortar.

Note 1: The material described in this specification may be used for blending with portland cement to produce a cement meeting the requirements of Specification C595/C595M or as a separate ingredient in concrete or mortar mixtures. The material may also be useful in a variety of special grouts and mortars, and when used with an appropriate activator, as the principal cementitious material in some applications.

Note 2: Information on technical aspects of the use of the material described in this specification is contained in Appendix X1, Appendix X2, and Appendix X3. More detailed information on that subject is contained in ACI 233R-17.2

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the inch-pound units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. Values are stated in only SI units when inch-pound units are not used in practice.

1.3 The text of this standard references notes and footnotes that provide explanatory information. These notes and footnotes (excluding those in tables) shall not be considered as requirements of this standard.

1.4 The following safety hazards caveat pertains only to the test methods described in this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM E2382-04(2012)

ASTM E2382-04(2012)

Standard Guide to Scanner and Tip Related Artifacts in Scanning Tunneling Microscopy and Atomic Force Microscopy

$34.00 $69.00

ASTM D7344-07

ASTM D7344-07

Standard Test Method for Distillation of Petroleum Products at Atmospheric Pressure (Mini Method)

$32.00 $65.00

ASTM D1478-07

ASTM D1478-07

Standard Test Method for Low-Temperature Torque of Ball Bearing Grease

$30.00 $60.00

ASTM D3828-07a

ASTM D3828-07a

Standard Test Methods for Flash Point by Small Scale Closed Cup Tester

$30.00 $60.00