Your shopping cart is empty!
ASTM International, 11/01/2017
Publisher: ASTM
File Format: PDF
$24.00$48.00
Published:01/11/2017
Pages:9
File Size:1 file , 120 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 These test methods cover tests for solvent containing varnishes primarily intended to provide electrical, mechanical, and chemical protection for electrical equipment. These test methods include tests for control and performance as follows:
Procedure
Section
Build
38 - 42
Dielectric Strength
43 - 48
Drainage
26 - 32
Flash Point
18 - 20
Nonvolatile Matter
21 - 25
Oil Resistance
54 - 56
Preparation of Test Specimens
7
Specific Gravity
9 - 12
Temperature Index
49 - 50
Time of Drying
33 - 37
Varnish Compatibility
51 - 53
Viscosity
13 - 17
1.2 Where the entire test method is included in this standard, the precision and bias are not known unless given in the stated method.
1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 5.
Note 1: There is no equivalent IEC standard.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Specification for Nickel-Chromium-Iron Alloys (UNS N06600, N06601, N06603, N06690, N06693, N06025, N06045, and N06696)* and Nickel-Chromium-Cobalt-Molybdenum Alloy (UNS N06617) Rod, Bar, and Wire
$30.00 $60.00
Standard Practice for Calculating Areas, Volume, and Linear Change of Refractory Shapes
$25.00 $50.00
Standard Guide for Structural Sealant Glazing
$47.00 $94.00
Standard Practice for Transfer Standards for Reflectance Factor for Near-Infrared Instruments Using Hemispherical Geometry