• ASTM D1331-20

ASTM D1331-20

Standard Test Methods for Surface and Interfacial Tension of Solutions of Paints, Solvents, Solutions of Surface-Active Agents, and Related Materials

ASTM International, 11/30/2020

Publisher: ASTM

File Format: PDF

$26.00$52.00


Published:30/11/2020

Pages:6

File Size:1 file , 88 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1''These test methods cover the determination of surface tension and interfacial tension of a variety of liquid materials, including but not restricted to paints, solvents, and solutions of surface-active agents, as defined in Terminology D459. Four methods are covered as follows:

Method A'''Surface Tension by du No''y ring;

Method B'''Interfacial Tension by du No''y ring;

Method C'''Surface Tension by Wilhelmy plate; and

Method D'''Interfacial Tension by Wilhelmy plate.

1.2''Method A originally was written primarily to cover aqueous solutions of surface-active agents, but is also applicable to aqueous paints, nonaqueous solutions (including paints) and mixed solvent solutions.

1.3''Method B is applicable to two-phase solutions. More than one solute component may be present, including solute components that are not in themselves surface-active.

1.4''Method C is applicable to surface active liquids and, unlike du No''y ring, no buoyancy corrections are needed and results are not affected by moderate viscosities (1-10 Pa-sec) of the liquid. It is the recommended method for use with paints and resin solutions.

1.5''Method D is applicable to two-phase solutions and mixtures.

1.6''The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.7''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Material Safety Data Sheets are available for reagents and materials. Review them for hazards prior to usage.

1.8''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM D1524-94(2010)

ASTM D1524-94(2010)

Standard Test Method for Visual Examination of Used Electrical Insulating Oils of Petroleum Origin in the Field

$26.00 $52.00

ASTM G144-01

ASTM G144-01

Standard Test Method for Determination of Residual Contamination of Materials and Components by Total Carbon Analysis Using a High-Temperature Combustion Analyzer

$25.00 $50.00

ASTM B338-10e1

ASTM B338-10e1

Standard Specification for Seamless and Welded Titanium and Titanium Alloy Tubes for Condensers and Heat Exchangers

$30.00 $60.00

ASTM A522/A522M-95b(2001)

ASTM A522/A522M-95b(2001)

Standard Specification for Forged or Rolled 8 and 9% Nickel Alloy Steel Flanges, Fittings, Valves, and Parts for Low-Temperature Service

$26.00 $52.00