ASTM D1405/D1405M-08(2013)

Standard Test Method for Estimation of Net Heat of Combustion of Aviation Fuels (Withdrawn 2019)

ASTM International, 05/01/2013

Publisher: ASTM

File Format: PDF

$30.00$60.00

Description

Published:01/05/2013

Pages:7

File Size:1 file , 97 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers the estimation of the net heat of combustion at constant pressure in SI units (megajoules per kilogram) or inch-pound units [Btu per pound].

1.2 This test method is purely empirical and is applicable only to liquid hydrocarbon fuels derived by normal refining processes from conventional crude oil, which conform to the requirements of specifications for aviation gasolines, or aircraft turbine and jet engine fuels of limited boiling ranges and compositions as described in Note 1.

Note 1-The estimation of the net heat of combustion of a hydrocarbon fuel from aniline-gravity product is justifiable only when the fuel belongs to a well-defined class for which a relation between heat of combustion and aniline-gravity product has been derived from accurate experimental measurements on representative samples of that class. Even in this case, the possibility that the estimates may be in error by large amounts for individual fuels should be recognized. The classes of fuels used to establish the correlation presented in this test method are represented by the following specifications:

Fuel	Specification
Aviation gasoline fuels:	Specification D910
Grades 80, 82, 100/130, and 115/145	Specification D6227
	DEF STAN 91-90
	NATO Code F-18

Aviation turbine fuels:	MIL-DTL-5624
JP-4,Avtag/FSII	DEF STAN 91-88
	NATO Code F-40

JP-5,Avcat/FSII	MIL-DTL-5624
	DEF STAN 91-86
	NATO Code F-44

Jet A, Jet A-1, Avtur	Specification D1655
	DEF STAN 91-91
	NATO Code F-35

1.3 This test method is not applicable to pure hydrocarbons. It is not intended as a substitute for experimental measurements of heat of combustion.

1.4 The heat of combustion may also be determined in SI units by Test Method D4529. Test Method D4529 requires calculation of a single equation for all aviation fuels with a precision equivalent to that of this test method.

1.5 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

More ASTM standard pdf

ASTM D4629-12

Standard Test Method for Trace Nitrogen in Liquid Petroleum Hydrocarbons by Syringe/Inlet Oxidative Combustion and Chemiluminescence Detection

$30.00 $60.00

ASTM D2609-15

Standard Specification for Plastic Insert Fittings for Polyethylene (PE) Plastic Pipe

$27.00 $54.00

ASTM C128-01

Standard Test Method for Density, Relative Density (Specific Gravity), and Absorption of Fine Aggregate

$30.00 $60.00

ASTM D6227-12

Standard Specification for Unleaded Aviation Gasoline Containing a Non-hydrocarbon Component

$30.00 $60.00