Your shopping cart is empty!
ASTM International, 11/10/2002
Publisher: ASTM
File Format: PDF
$30.00$60.00
Published:10/11/2002
Pages:7
File Size:1 file , 130 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method describes two procedures for the measurement of the density of materials which are fluid at the desired test temperature. Its application is restricted to liquids of vapor pressures below 600 mm Hg (80 kPa) and viscosities below 40000 cSt (mm²/s) at the test temperature. The method is designed for use at any temperature between 20 and 100°C. It can be used at higher temperatures; however, in this case the precision section does not apply.
Note 1 - For the determination of density of materials which are fluid at normal temperatures, see Test Method D 1217.
1.2 This test method provides a calculation procedure for converting density to specific gravity.
1.3 The values stated in acceptable SI units are to be regarded as the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements see Note 1 and Note 2.
Standard Specification for Gray Iron Castings for Valves, Flanges, and Pipe Fittings
$26.00 $52.00
Standard Test Methods for Rubber-Evaluation of BIIR and CIIR (Halogenated Isobutene-Isoprene Rubber)
$32.00 $64.00
Standard Specification for Installation of Lathing and Furring to Receive Interior and Exterior Portland Cement-Based Plaster
$30.00 $60.00
Standard Specification for Primary Amyl Acetate, Synthetic (98 % Grade)