Your shopping cart is empty!
ASTM International, 12/01/2008
Publisher: ASTM
File Format: PDF
$30.00$60.00
Published:01/12/2008
Pages:7
File Size:1 file , 120 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method covers three procedures for the determination of total sulfur in petroleum products including lubricating oils containing additives, and in additive concentrates. This test method is applicable to samples boiling above 177°C (350°F) and containing not less than 0.06 mass % sulfur. Two of the three procedures use iodate detection; one employing an induction furnace for pyrolysis, the other a resistance furnace. The third procedure uses IR detection following pyrolysis in a resistance furnace.
1.2 Petroleum coke containing up to 8 mass % sulfur can be analyzed.
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Test Methods for Physical and Chemical Properties of Particulate Ion-Exchange Resins
$34.00 $69.00
Standard Test Method for Parting Strength of Mineral Fiber Batt- and Blanket-Type Insulation
$26.00 $52.00
Standard Specification for Wrought Zirconium and Zirconium Alloy Seamless and Welded Tubes for Nuclear Service (Except Nuclear Fuel Cladding)
$33.00 $67.00
Standard Specification for Low-Alloy Steel Deformed and Plain Bars for Concrete Reinforcement
$30.00 $60.00