Your shopping cart is empty!
ASTM International, 09/10/2002
Publisher: ASTM
File Format: PDF
$30.00$60.00
Published:10/09/2002
Pages:5
File Size:1 file , 53 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method cover procedures for testing the strength of adhesion of single-filament wire to vulcanized rubber compounds. The method applies to, but is not limited to, wire made from brass, bronze, or zinc coated steel wire. The adhesion strength is expressed as the magnitude of the pull-out force for the single filament of wire.
1.2 This test method is applicable to single-filament wires used in reinforced rubber products as single filaments and is normally used to evaluate the adhesion of samples of wire to a standard rubber applied under specified conditions. It is primarily used to evaluate tire bead wire and may be applied, with modifications and by agreement between supplier and customer, to various wire types used in rubber product reinforcing.
1.3 This test method is written in SI units.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See 6.5.1.
Standard Test Methods for Photovoltaic Modules in Cyclic Temperature and Humidity Environments
$25.00 $50.00
Standard Practice for Selection, Design, Installation, and Inspection of Water Vapor Retarders Used in Contact with Earth or Granular Fill Under Concrete Slabs
Standard Test Method for Elastic Properties of Elastomeric Yarns (CRE Type Tensile Testing Machines)
$31.00 $62.00
Standard Specification for Nickel-Chromium-Molybdenum-Columbium Alloy (UNS N06625), Nickel-Chromium-Molybdenum-Silicon Alloy (UNS N06219), and Nickel-Chromium-Molybdenum-Tungsten Alloy (UNS N06650)* Rod and Bar
$29.00 $58.00