• ASTM D1971-16(2021)e1

ASTM D1971-16(2021)e1

Standard Practices for Digestion of Water Samples for Determination of Metals by Flame Atomic Absorption, Graphite Furnace Atomic Absorption, Plasma Emission Spectroscopy, or Plasma Mass Spectrometry

ASTM International, 11/01/2021

Publisher: ASTM

File Format: PDF

$27.00$54.00


Published:01/11/2021

Pages:6

File Size:1 file , 110 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1''Most atomic absorption and plasma emission spectroscopy, and plasma-mass spectrometric test methods require that the metals of interest be dissolved in a liquid phase before being introduced into the spectrophotometer. These practices describe digestion or dissolution procedures whereby analyte metals associated with the solid fraction of a sample can be brought into solution for subsequent analysis. The following practices are included:

''

Sections

Practice A'''Digestion with Mineral Acids and
'''Elevated Pressure

'''8 through 13

Practice B'''Digestion with Mineral Acids and
'''Heating at Atmospheric Pressure

14 through 19

Practice C'''In-Bottle Digestion with Mineral Acids

20 through 25

1.2''These practices have been demonstrated to be applicable to a wide variety of sample types and sample matrices, and in many cases, will give complete dissolution of the analyte metals of interest. They are by no means the only digestion procedures available.

1.3''The user of these practices should be cautioned that these practices may not completely dissolve all portions of a sample's solid phase and may not give complete recovery of the desired analyte metals. In these cases, other digestion techniques are available that will effect complete dissolution of a sample. It is the user's responsibility to ensure the validity of these practices for use on their particular sample matrix, for their metals of interest.

1.4''This practice assumes that the criteria established in Guide D3856 can be met.

1.5''These digestion procedures have been selected for their wide application, low cost, and ease of use.

1.6''The values stated in SI units are to be regarded as the standard. The values given in parentheses are mathematical conversion to inch-pound units that are provided for information only and are not considered standard.

1.7''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in Section 6.

1.8''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM D4455-85(2014)

ASTM D4455-85(2014)

Standard Test Method for Enumeration of Aquatic Bacteria by Epifluorescence Microscopy Counting Procedure (Withdrawn 2019)

$26.00 $52.00

ASTM D1562-09

ASTM D1562-09

Standard Classification System and Basis for Specification for Cellulose Acetate Propionate Molding and Extrusion Compounds

$30.00 $60.00

ASTM MNL32

ASTM MNL32

Manual of Testing Sieving Methods: Guidelines for Establishing Sieve Analysis Procedures (5th Edition)

$117.00 $235.50

ASTM C361-14a

ASTM C361-14a

Standard Specification for Reinforced Concrete Low-Head Pressure Pipe

$43.00 $86.00