Your shopping cart is empty!
ASTM International, 12/01/1999
Publisher: ASTM
File Format: PDF
$29.00$58.00
Published:01/12/1999
Pages:7
File Size:1 file , 40 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers polyethylene (PE) pipe made in Schedule 40 size for use with insert fittings (inside diameter controlled) and pressure-rated for water (see Appendix). Included are criteria for classifying PE plastic pipe materials and PE plastic pipe, a system of nomenclature for PE plastic pipe, and requirements and test methods for materials, workmanship, dimensions, sustained pressure, burst pressure, and environmental stress cracking. Requirements for marking are also given.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 The following safety hazards caveat pertains only to the test methods portion, Section 7, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Specification for Deformed Polyethylene (PE) Liner
$25.00 $50.00
Standard Test Method for Silica - ;pH Value
Standard Test Method for Silanes Used in Rubber Formulations (bis-(triethoxysilylpropyl)sulfanes): Residue on Ignition
Standard Specification for Automotive Spark-Ignition Engine Fuel
$43.00 $86.00