• ASTM D2234/D2234M-17

ASTM D2234/D2234M-17

Standard Practice for Collection of a Gross Sample of Coal

ASTM International, 10/15/2017

Publisher: ASTM

File Format: PDF

$30.00$60.00


Published:15/10/2017

Pages:6

File Size:1 file , 82 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This practice covers procedures for the collection of a sample under various conditions of sampling. The sample is to be crushed and further prepared for analysis in accordance with Practice D2013/D2013M. However, the procedures for dividing large samples before any crushing are given in this practice. For the sampling of coal using mechanical sampling systems see D7430 Practice for the Mechanical Sampling of Coal.

1.2 This practice describes general and special purpose sampling procedures for coals (1) by size and condition of preparation (for example, mechanically cleaned coal or raw coal) and (2) by sampling characteristics.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM C1449/C1449M-05a(2010)

ASTM C1449/C1449M-05a(2010)

Standard Specification for Non-Asbestos Fiber-Cement Nonpressure Sewer Pipe

$30.00 $60.00

ASTM D6556-10

ASTM D6556-10

Standard Test Method for Carbon Black-Total and External Surface Area by Nitrogen Adsorption

$30.00 $60.00

ASTM D5211-10

ASTM D5211-10

Standard Specification for Xylenes for p-Xylene Feedstock

$26.00 $52.00

ASTM D2444-99(2010)

ASTM D2444-99(2010)

Standard Test Method for Determination of the Impact Resistance of Thermoplastic Pipe and Fittings by Means of a Tup (Falling Weight)

$30.00 $60.00