Your shopping cart is empty!
ASTM International, 05/01/2015
Publisher: ASTM
File Format: PDF
$32.00$65.00
Published:01/05/2015
Pages:13
File Size:1 file , 300 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 These test methods cover procedures for sampling, examination, physical testing, and analyses of asphalt-containing materials used in roofing and waterproofing. These materials include but are not limited to roll roofing, cap sheets, and shingles. Any of these materials are allowed to be partially or fully coated, surfaced, or laminated, or a combination thereof.
1.2 The test methods and procedures in this standard appear in the following order:
Section
Content
6
Types of Roofing
7
Sampling
8
Mass and Area Determination
9
Selection of Representative Specimens
10
Moisture
11
Pliability
12
Mass Loss and Behavior on Heating
13
Tear Strength
14
Fastener Pull-Through Resistance
15
Preparation and Selection of Small Test Specimens for Analyses
16
Analysis of Glass Felt Products
17
Analysis of Roofing Products with Organic Felts
18
Ash of Desaturated Felt
19
Calculation
20
Adjusting Back Coating Fine Mineral Matter and Back Surfacing
21
Report
22
Precision and Bias
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Test Method for Corrosivity Index of Plastics and Fillers
$26.00 $52.00
Standard Specification for Nickel-Iron-Chromium-Silicon Alloy Bars and Shapes
$30.00 $60.00
Standard Test Method for Determination of Moisture in Plastics by Relative Humidity Sensor
$25.00 $50.00
Standard Classification System for Poly(Methyl Methacrylate) (PMMA) Molding and Extrusion Compounds
