Your shopping cart is empty!
ASTM International, 05/01/2021
Publisher: ASTM
File Format: PDF
$26.00$52.00
Published:01/05/2021
Pages:6
File Size:1 file , 190 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1''This test method describes procedures for the measurement of gloss of plastic films and solid plastics, both opaque and transparent. It contains four separate gloss angles (Note 1):
1.1.1''60-deg, recommended for intermediate-gloss films,
1.1.2''20-deg, recommended for high-gloss films,
1.1.3''45-deg, recommended for intermediate and low-gloss films,
1.1.4''85-deg, recommended for intermediate and low gloss films, and
1.1.5''75-deg, recommended for plastic siding and soffit.
Note 1:''The 85-deg, 75-deg, 60-deg, and 20-deg apparatus and method of measurement duplicate those in Test Method D523 and D3679; those for the 45'' procedure are similarly taken from Test Method C346.
1.2''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
Note 2:''There is no known ISO equivalent to this standard.
1.3''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Test Method for Calibration of Atmospheric Corrosion Test Chambers by Change in Mass of Copper Coupons
$32.00 $64.00
Standard Test Method for Evaluation of MR Image Artifacts from Passive Implants
$25.00 $50.00
Standard Test Method for Dropping Point of Lubricating Grease Over Wide Temperature Range
$30.00 $60.00
Standard Specification for Copper and Copper-Alloy Seamless Condenser Tubes and Ferrule Stock
$33.00 $67.00
