Your shopping cart is empty!
ASTM International, 02/01/2013
Publisher: ASTM
File Format: PDF
$28.00$57.60
Published:01/02/2013
Pages:17
File Size:1 file , 210 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers requirements and test methods for material dimensions and tolerances, hydrostatic burst strength, chemical resistance, and rapid crack resistance of polyethylene pipe, tubing, and fittings for use in fuel gas mains and services for direct burial and reliner applications. The pipe and fittings covered by this specification are intended for use in the distribution of natural gas. Requirements for the qualifying of polyethylene systems for use with liquefied petroleum gas are also covered.
1.1.1 This specification does not cover threaded pipe. Design considerations are discussed in Appendix X1. In-plant quality control programs are specified in Annex A1 and Annex A2.
1.1.2 See Specification F2619/F2619M for polyethylene piping for pressure or non-pressure oil and gas producing applications to convey fluids such as oil, dry or wet gas, multiphase fluids, and non-potable oilfield water.
1.2 The text of this specification references notes, footnotes, and appendixes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the specification.
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 The following is an index of the annexes and appendix in this specification:
Annex
Subject
Annex A1
In-Plant Quality Control for all materials up to 12 in.
Annex A2
In-Plant Quality Control for PE materials 14 in. and larger.
Appendixes
Appendix X1
Design Consideration
1.5 The following precautionary caveat pertains only to the test method portion, Section 6, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Terminology Relating to Liquid Particles and Atomization
$27.00 $54.00
Standard Test Method for Conducting Rotating Bending Fatigue Tests of Solid Round Fine Wire
Standard Specification for High Load Multi-Rotational Disc Bearings for Bridges and Structures
$28.00 $57.00
Standard Test Method for Lipid Quantitation in Liposomal Formulations Using Ultra-High-Performance Liquid Chromatography (UHPLC) with Triple Quadrupole Mass Spectrometry (TQMS)
$30.00 $60.00
